CRA named authorised Ro-Flo packager and distributor for India

In this Article

CRA is an authorised packager and distributor for Ro-Flo Compressors. The authorisation reflects a relationship built on delivered projects.

‍

The partnership exists because proven compression technology requires an engineering team that knows how to put it to work.

‍

The Partnership

‍

Ro-Flo Compressors manufactures rotary sliding vane compressors and all associated OEM parts, with applications across biogas, vapour recovery, landfill gas, and wastewater treatment. The sliding vane design delivers continuous compression with no valves, handles gas gently, and suits the saturation and variability that biogas streams bring.

‍

As an authorised packager and distributor, CRA engineers the complete system around the Ro-Flo compression unit. That scope covers inlet filtration, dehumidification, gas train design, skid fabrication, controls integration, and commissioning, all built in house. CRA holds a direct technical relationship with Ro-Flo's engineering department, with access to Ro-Flo technical input during project execution. OEM parts are used exclusively for all supply and aftermarket servicing.

‍

Ro-Flo supplies the compression unit and CRA engineers the system around it.

‍

Proven in the Field

‍

Two projects demonstrate what this combination delivers.

‍

For a dairy biogas plant in Oman, CRA engineered a compression skid to transport biogas across a long-distance pipeline, operating continuously in desert heat with a duty and standby Ro-Flo configuration. The system has been in operation since commissioning. Read the case study →

‍

For Adani's anaerobic digester facility in India, the requirement was more complex: biogas recirculated sequentially through multiple lances across three RCC digesters, with a dedicated Ro-Flo unit and standby per channel, controlled by a modulating rotary sequential valve system. The project delivered a 15% increase in biogas yield and 54% cost savings against the alternative. Read the case study →

‍

Both systems are successfully commissioned and in operation today.

‍

What This Means for Your Project

‍

Most biogas compression projects involve at least two parties: the compressor supplier and the system integrator. When those are separate, the risk sits in the gap between them. Typical problems are inlet gas specifications that do not match the compressor's actual requirements, preconditioning that is adequate in isolation but not designed to the machine's inlet needs, and controls that treat the upstream system and the compression unit as separate equipment rather than one process. That gap is where most field problems originate.

‍

As an authorised packager, CRA closes that gap. The technology selection, the preconditioning design, and the controls architecture are engineered together, by one team, to one set of process conditions. There is no split between a compressor supplier and a balance of plant contractor. The accountability for the outcome sits in one place.

‍

For the customer, the authorised packager relationship delivers three things.

‍

Full system integration from inlet gas to discharge, with the compressor and all surrounding engineering under one scope and one accountable party. There is no split responsibility between a compression supplier and a balance of plant contractor.

‍

Genuine OEM parts for supply and servicing, and a direct line between CRA and Ro-Flo's engineering department during design review, commissioning and servicing, so there is no gap between the equipment manufacturer and the system integrator.

‍

A formalised supply chain, in which authorised distribution means lead times and parts availability are planned as part of the project from the start rather than handled as procurement risk during execution.

‍

What's Next

‍

Biogas compression requirements are growing, across India's CBG programme, across wastewater and landfill gas projects regionally, and in markets where biogas to energy infrastructure is scaling at commercial pace. Each of those projects requires a compression system that performs to specification reliably, across variable feedstock, seasonal gas compositions, and load cycles.

‍

CRA is positioned to deliver that system, with Ro-Flo compression engineered at its core, and one point of accountability for the outcome.

Custom engineered. Properly scoped.

Speak to an engineer